Reserve issue
Funny you should say that Stig.
When I stopped to take some photos and turned the bike off. When I turned it back on again the pump was clicking and didn't shut off. I turned it off and back on again and it stopped clicking. It did this a couple of times on the trip and I put it down to the heat of the day. My ride out yesterday was fine with the pump and no clicking. I have a spare pump so I'll stick that on this week. That's a nice little job seeing as it's going to be shi*te weather this coming week.
When I stopped to take some photos and turned the bike off. When I turned it back on again the pump was clicking and didn't shut off. I turned it off and back on again and it stopped clicking. It did this a couple of times on the trip and I put it down to the heat of the day. My ride out yesterday was fine with the pump and no clicking. I have a spare pump so I'll stick that on this week. That's a nice little job seeing as it's going to be shi*te weather this coming week.
Bit of advice. Buy a good bed and a good pair of shoes, because if you aren't in one you'll be in the other.
Set about today to see what the problem could be with the petrol reserve and guess what I came across? As I was soldering the red wire back on the other wire came off too. So they are both well and truly fixed back on now. I'll try it out when the weather picks up a bit. I'm not sure if this will have sorted it or not??
Bit of advice. Buy a good bed and a good pair of shoes, because if you aren't in one you'll be in the other.
- Graham Crayon
- Scooter Boy
- Posts: 60
- Joined: Tue Oct 19, 2010 3:40 pm
- Location: Worcestershire
- Contact:
That White block above your fuel pump, some kind of resistor I hear? To do with the reserve system. Neglected to fit (lost) mine after restoring it so now bike only runs on reserve. Switch to "on" position & it runs out of fuel after not very long at all. Yours could be duff or have bad connection?
Life's short & it's hard like a body building elf
-
- Spanner Monkey
- Posts: 124
- Joined: Sat Jun 13, 2009 12:30 am
- Location: somerset
If you don't have the reserve switch fitted. If you run it and run it then you could run out of petrol without the warning signs of the engine starting to stutter. When you fill up with petrol wind the trip meter on the clocks till you have all zero's. Then when you get to say 100 miles make sure you fill up again.
I'm not sure what you mean by plugged in? You won't hear anything from the switch when you switch it over on to normal running or reserve. I think you're meaning the fuel pump clicking when it's priming the carbs when turning the ignition on.
I'm not sure what you mean by plugged in? You won't hear anything from the switch when you switch it over on to normal running or reserve. I think you're meaning the fuel pump clicking when it's priming the carbs when turning the ignition on.
Bit of advice. Buy a good bed and a good pair of shoes, because if you aren't in one you'll be in the other.
Just an update to this problem I had. Glad to say after soldering those wires back on properly it is now back to normal.nuggitt wrote:Set about today to see what the problem could be with the petrol reserve and guess what I came across? As I was soldering the red wire back on the other wire came off too. So they are both well and truly fixed back on now. I'll try it out when the weather picks up a bit. I'm not sure if this will have sorted it or not??
I don't know why the photo has disappeared??
Bit of advice. Buy a good bed and a good pair of shoes, because if you aren't in one you'll be in the other.
-
- Spanner Monkey
- Posts: 124
- Joined: Sat Jun 13, 2009 12:30 am
- Location: somerset
- oldskoolexup
- Motormouth
- Posts: 1219
- Joined: Sun Jul 19, 2009 11:45 am
- Location: THE place...some are born here, some drawn here...Manchester
The reserve switch contacts on my RU must have been dirty when I got it as it was playing up......a good dose of switch cleaner solvent seemed to sort it.
I've not looked at how the ignitor circuit works but the switch seems to "force" the fuel pump to continue pressurising fuel ignoring the thermistor circuit in the tank when it becomes uncovered when at a low level.
Have I got that right lads?
I've not looked at how the ignitor circuit works but the switch seems to "force" the fuel pump to continue pressurising fuel ignoring the thermistor circuit in the tank when it becomes uncovered when at a low level.
Have I got that right lads?
Life begins at the end of your comfort zone,
Learn from the mistakes of others.............................
You can't live long enough to make them all yourself
&
Carpe Diem - seize the moment. Don't dream... Do!
Learn from the mistakes of others.............................
You can't live long enough to make them all yourself
&
Carpe Diem - seize the moment. Don't dream... Do!
- oldskoolexup
- Motormouth
- Posts: 1219
- Joined: Sun Jul 19, 2009 11:45 am
- Location: THE place...some are born here, some drawn here...Manchester
.....not many folk of your advanced years still riding!nuggitt wrote:I think it was Fang who did a write up about that subject. I'll try and find it when I get home.
That's you and a few others off the Christmas card list. Insults nothing but insults.
Life begins at the end of your comfort zone,
Learn from the mistakes of others.............................
You can't live long enough to make them all yourself
&
Carpe Diem - seize the moment. Don't dream... Do!
Learn from the mistakes of others.............................
You can't live long enough to make them all yourself
&
Carpe Diem - seize the moment. Don't dream... Do!