Exup 1000

Well the part arrived (from fowlers) good fast delivery
All put back together. When I first tightened the housing there was quite a bit of resistance in the valve turning freely but I thought I will get it all back together and see what happened.
When I put the pulley on and did the bolt up it ...

https://youtu.be/HijXJGhiLvM

Here is my video.
As you can see when I point the camera in the exhaust you can see the Bush is still in its place inside the exhaust. I have the spring and washer on the housing end. There should be two parts on the far side spindle on the valve. One like I said is ...

I think what would be best is for me to take a picture of all the components I have and then you kind people could tell me what is missing

It's the spacer on the pic with all the components

Guessing it's the small Bush.

It's called the collar. It goes on the far side spindle

Well I have stripped my exup valve for maintenance.
Silly me didn't know about the washer on the other side of the valve on the spindle when I took it out and now I can't find it... either I have lost it or it didn't have one in the first place. Does anyone know anywhere that will just sell one of ...

No bike wasn't stored. No not hard to find neutral. Goes through all the gears perfectly

well its bad news :( Took the bike out this morning and it was slipping again. once the bike is warmed up though the clutch stopped slipping at all. A few people have asked what oil was used in the last oil change as some bike dont like certain oils. i spoke to previous owner and he says he bought ...

Well everything is put back together system bled. pissing down with rain i just couldn't resist going for a ride, so at the start the clutch was slipping for the first 5-10 mins then magically stopped slipping at all. Now i am really hoping that is problem sorted but for some reason in the back of ...

Also any advise on how to get it in there as well

Please tell me if this bit fits into that hole where the rod sits? I have been trying to get it in there but really struggling. If so which way round does it go as I'm sure there wasn't one on there when I took it apart

https://imageshack.com/i/poc1LBTkj

https://imageshack.com/i/poc1LBTkj

Thanks for the confirmation stig. Much appreciated

It's not that bit I'm worried about. It's the part the slave cylinder case bolts onto the engine. Here is a picture. Probably me being stupid at a guess.
From the start of this thread I said I undid the clutch slave cylinder case and was told I would need to bleed the system. But the case isn't a ...