Exup 1000

Hi Stig, is it any year that should fit or just the later ru ones?

That's alright it is only the front end that needs to fit, the back end I will sort when I have a stainless set

hi all, I'm back!!

After a year and a few months of moving out, moving in, moving out, moving in and refurbishing I have finally decided it's time to pick this project back up.

I have got a TPS from ebay and will be fitting it to the bike soon, how do I adjust them and know they are correct?

I got everything connected up but no start up :(

I can smell the fuel so there's fuel getting through the system, I'll start all the usual other checks this weekend.

I did notice however that the rev counter is flicking up to 3000rpm indicating a fault with the throttle position sensor (TPS). Does ...

That's perfect, thanks chaps

If it leaks I'll get a washer for it.

I suppose it could be that, or even just an overflow hose, I can't remember where the hoses go though

Thanks for getting back so quickly though

I got the cooling system cobbled together, and the electrics are laid in place all ready for trying to fire the bike up. I would have tried it last night but realised that Yamaha switched from a single pump/level sensor to separate items on the thunderace and I didn't have my soldering gear to ...

I do have the thunderace one fitted, but not plumbed up as yet, it will be by the end of the week though

I tested the electrics last week and they seem to work, now time for the cooling system. Quite obviously I have a thunderace engine, with a 750 chassis. I plan on using the 750 flat radiator (at least for now) but read that you need to also use the 750 oil filter housing. Looking on a thunderace ...

Me too, completely winging it at the moment, not really sure what I'm doing with a lot of it

Going for a stealthfighter

Well after 3 week of ignoring the engine in a frame, sat on the floor. I finally decided it's time to make some progress.

I managed to get the frame and engine up onto some forks, refit the swing arm, shock and wheels and make it look like a bike again.

http://i599.photobucket.com/albums/tt76 ...

I've been busy all week making an adaptor bracket for the aprilia, but the carbs are on the engine, the coils are temporarily in (until I swap them for stick coils to free up some space under the airbox.

I was going to just dump pod filters in there, but I'm going to have a look when I comes to fitting them and make a decision then[/url]

Don't worry, these will come. But at the minute it's an engine in a frame on the floor

Here are my engine mounts modified (I didn't do it, but thanks to GIA Engineering in nottingham)