Ohlins Shock - Standard Settings ?

redrocks · Post by **redrocks** » Tue Apr 22, 2014 12:29 pm

I have an Ohlins S46HR1C1 shock but I'm not sure of the "standard" settings. Does anyone have experience of this shock (or similar)? The range of adjustment (clicks) is pretty large. At the moment I'm about midway on both compression and rebound? Apologies if this type of question has been asked before - I can't seem to find a good general setting !!

yzfpaul · Post by **yzfpaul** » Tue Apr 22, 2014 2:41 pm

rear pre-load = position 3
rear rebound damping = nine clicks out
rear compression damping = ten clicks out

Try these settings as a base after you set up the sag

redrocks · Post by **redrocks** » Tue Apr 22, 2014 2:45 pm

Ok - I'll give them a go.......my current settings are probably midway i..e about 14-15 clicks out on both. I've set the sag so thats OK too.