potential exup eater

Post by **Stig** » Wed Aug 27, 2008 10:10 pm

as per my post in lounge about the item I bought off ebay

I'd like to share our latest project ...OMG

This was this morn before I went to work. The barrel was off and it wouldn't turn over

when I got home

half hour later

Time to find the prob of it not turning over

The crank appears to be locked

look what fell out

The cranks fooked BTW $:\$

Exupnutta · Post by **Exupnutta** » Wed Aug 27, 2008 10:33 pm

Stig wrote:
look what fell out

The cranks fooked BTW $:\$

... at least you got some money back

yzfkev · Post by **yzfkev** » Wed Aug 27, 2008 10:39 pm

you shouldnt work on machinery with open toed shoes on

you should know better

re last picture $:\$

STEVE · Post by **STEVE** » Wed Aug 27, 2008 10:47 pm

you shouldnt work on machinery with open toed shoes on you should know better re last picture

and socks aswell

Post by **Stig** » Wed Aug 27, 2008 10:49 pm

I'd been in the house to fetch the camera....couldn't be arsed to put the shoes back on so slipped me daps on to get to the garage

1040EXUP · Post by **1040EXUP** » Thu Aug 28, 2008 6:01 pm

lucky they werent white socks - we'd be looking for your holy book next!!!

Weaver · Post by **Weaver** » Thu Aug 28, 2008 7:53 pm

I think that was the penny for your thoughts as it dropped out.

Most probably one of the local kids was dared to spend a penny in the gearbox oil.

good luck with the rebuild..

Post by **Stig** » Thu Aug 28, 2008 8:21 pm

Weaver wrote:I think that was the penny for your thoughts as it dropped out.
good luck with the rebuild..

Think you're right about the penny. The thought was single worded starting with F

Managed to get the flywheel off today, just need to split the casing to check out the carnage

Job for tomorrow night by the looks of things

EXUP FREAK · Post by **EXUP FREAK** » Thu Aug 28, 2008 8:57 pm

motor is neerley as bad as the

lambretta one ive got

Post by **Stig** » Sat Aug 30, 2008 6:26 pm

got the casings split

can't find the prob

Theres a bearing in two halves in the bottom of the casing

...along with the rest of the race

Post by **Stig** » Sat Sep 06, 2008 2:51 pm

as you see in my other post, the cranks sorted and currently chillin ready for the new bearings to be installed

....that don't mean we've been sat on our Rses

The exhaust had the treatment today and the panels are being prepped ready for paint. The centre stands been blasted and repaired, and is painted and finished. Lots of other small bits have been done ready for the re-assemble

BEFORE

AFTER

scar_biker · Post by **scar_biker** » Sat Sep 06, 2008 4:40 pm

If polishing was Olympic event you'd get Gold

Rutz · Post by **Rutz** » Sun Sep 07, 2008 8:11 pm

You'll be buying a parka next

hear Jon's got one

Exup 1000

potential exup eater

potential exup eater

Re: potential exup eater